This model is heavily modified!
Making an erect penis model is a complicated process because the software we use to make 3D models from photos is very sensitive to movement. However, humans are constantly moving via breathing, heartbeats and other involuntary movements. Holding a pose in an uncomfortable situation for 45 seconds without breathing is challenging for the model and even with the best efforts this causes most 3D model creation process to fail.
This model has been constructed from 3 separate scans, and the top was especially difficult to reconstruct. The tip of the penis is the point that has the greatest amount of movement, making it near impossible to get a scan without movement at all. We had to do a lot of manual post processing to create an acceptable model.
This is the first working scan of an erect penis that we were able to create. We thank all the human models who allowed us to do test shootings, for their patience, dedication and the courage to try this!
For informaton on how to 3D print or order 3D prints of these models, please read our model printing guidelines. To download a model or a surface, select a file below:
|STL file format, ready for 3D printing
|2 MB download size
|STL file format, suited for 3D modeling
|1 MB download size
If you don't have access to a 3D printer or know anyone who does, you can also have these models custom printed and mailed to you. If you'd like to order a print, press the button below to open a new tab to start the order.
Unless you are experienced with 3d printing, we recommend that you read our tips on how to order a print. The cost for simple penis or vulva prints (10cm, PLA) will likely €20-€30 ($25-$35), which isn't bad if you don't have access to a printer. Other models, sizes and materials will increase the cost quite a bit.
Note: We are not affiliated with CraftCloud and we do not earn any money referrring you to them. We just think their prices and their web site are a good match for our users. (And their team was helpful!)